I should note that all Dante audio is uncompressed and totally lossless. That depends on the audio format that your are using. However, depending on the version of Windows 10 you have, one of the following conditions may be observed: The workaround involves uninstalling Dante Virtual Soundcard and reinstalling it, then setting the required sample rate in ASIO mode BEFORE it is started. EXP2x Details Dante - Digital Media Networking Made Easy Dante Sample Rate – The rate of the Dante Option card. Dante devices that have been 'misplaced' are those that have been configured with a static IP address which falls outside the subnet that the Dante Controller computer is on (or more specifically, the subnet configured on the network interface which is selected in Dante Controller as the primary network interface). If the Pro Tools application has been launched but no session is open, the sample rate may be set in Pro Tools > Setup menu > Hardware. On Windows 10, to change the sample rate for Dante Virtual Soundcard, you must first change it in Dante Controller, and then change it for each DVS device in the Windows Playback and Recording device settings.
In Final Cut, select your sequence in the Browser and File > Send it to Soundtrack Pro. I just replaced my old rig with an RME Fireface800. Changes require a device reboot via Tesira software's Device Maintenance "Reboot Device" button or power cycle to take effect. (V2.0 and later) Displays the Dante version of the connected NY64-D, if installed. I am using audioweaver with a dante network to feed audio to a system. A quick note when using Windows with ASIO, the audio software will dictate to DVS what sample rate and bit depth are to be used. To check it, go to Soundtrack Pro > Preferences > Project tab and make sure the project sample rate is set to 48000 (48 kHz). So as my kids will be asleep upstairs while this duel takes place I thought that instead of trying to mic up a real amp, using the helix via USB should mean I can have the guitar tone go straight into the zoom meeting with no risk of waking the kids :-) The Symphony I/O sample rate is set in Dante Controller > Device View > Device Config tab.Â. The Tesira device's encoding bit-depth can be altered using Dante Controller software.
I know what to do (or what not to do) now and it works just fine but I can?t re-record this one and looking for ways to solve this particular project. Symphony I/O Sample Rate – The rate of the Symphony I/O chassis, i.e.
0 kommentar(er)
